DeWalt D28715, Single bevel, 4000 RPM, 140 x 140 mm, 120 x 120 mm, 112 dB, 3, 100
Fördelar och nackdelar
av våra specialister
Denna metallkapmaskin är gjord för snabb kapning av metallprofiler och rör i verkstad eller på plats. Den levereras med en stor klinga och är byggd för tunga kapningsjobb. Den passar främst användare som gör mycket raka och grova snitt.
Recensioner av DeWalt D28715, Single bevel, 4000 RPM, 140 x 140 mm, 120 x 120 mm, 112 dB, 3, 100
Baserat på 112 recensioner
Doesn't make straight cuts, it walks away from you even with a small amount of pressure. Slight pressure and you can see the disc bend away from the original entry cut. I should have researched before I purchased - the whole point of buying a chop saw was to help make straight cuts faster.
Doesn't make straight cuts, it walks away from you even with a small amount of pressure. Slight pressure and you can see the disc bend away from the original entry cut. I should have researched before I purchased - the whole point of buying a chop saw was to help make straight cuts faster.
Josh435
6 oktober 2023
The rear gate does not lock well into place and will not stay square. The motor mount won't stay square also. Nice motor and blade safety.
The rear gate does not lock well into place and will not stay square. The motor mount won't stay square also. Nice motor and blade safety.
F of P
11 april 2023
Hinge pin is not square. Not talking about the fence; you can fix it square with some fiddling. Cuts maybe 1/2" square-bar ok. But put a 1/4 x 1" bar in vertically (the way it ought to be cut) and you'll find the bottom is 3/32" longer than the top. Cut a 3" square tube and you'll find the bottom is 1/4" longer. There is no adjustment for this except guessing the shim size you need to prop up the stock. LOTS of post cut grinding. Unacceptable.
Hinge pin is not square. Not talking about the fence; you can fix it square with some fiddling. Cuts maybe 1/2" square-bar ok. But put a 1/4 x 1" bar in vertically (the way it ought to be cut) and you'll find the bottom is 3/32" longer than the top. Cut a 3" square tube and you'll find the bottom is 1/4" longer. There is no adjustment for this except guessing the shim size you need to prop up the stock. LOTS of post cut grinding. Unacceptable.
Dave who wanted better
18 januari 2021
It seemed well made , but it does require at least a 30 amp power supply , and then was not able to add any weight to the cut pressure or it would pop the 30 amp breaker.
It seemed well made , but it does require at least a 30 amp power supply , and then was not able to add any weight to the cut pressure or it would pop the 30 amp breaker.
grgjhnsn
24 juni 2020
Second one I bought. First one smashed hooked to 220 by one of the kids but still ran like a champ until it died.
Second one I bought. First one smashed hooked to 220 by one of the kids but still ran like a champ until it died.
HomeDepotCustomer
16 juni 2020
